Call us 087-7840908 E-mail stephen@provend.ie
Necta Rondo
Classic Combination Machine
Rondo - All round innovation!
Rondò is a vending machine for dispensing snacks, bottles, cans and Tetra-Pak containers and offers an excellent capacity to size ratio and a very refined design, allowing easy positioning in a bank of vending machines.
A solution conceived for busy sites as customers can enjoy maximum visibility of the product displayed due to the large illuminated glass front.
INNOVATIONS
Rondò is equipped with a slide-in/slide-out cooling unit, which is easy to remove, and is fitted with a hot air outlet at the front (patented). The machine can therefore be positioned against a wall without damaging the cooling unit and thus save 10 cm on the depth of the machine. In addition, the unit needs limited maintenance, as the ventilation grille is easy to remove and clean.
The Rondò has an extremely sturdy ergonomic product dispensing compartment (patented), an antitheft device and a slow motion closing mechanism. An optional kit is available which will block the dispensing compartment when the vending machine is not being used. However, when a product is dispensed it will open for a programmable length of time to allow the item to be collected.
The tiltable trays, conceived for easy product loading, can be very simply transformed into fixed trays by inserting a small metal insert (patented) that prevents tilting.
TEMPERATURE
The temperature of the Rondò can be even (8-12°C), programmable as a single value via the software, or in stratified (5-8°C approximately in the lower trays and 8-14°C in the upper trays), achieved by closing the special shutters on the air duct located on the back wall of the refrigerated box.
ELECTRONICS
The 16-bit electronic control with incorporated flash EPROM is extremely flexible and complete. It allows the automatic setup and reading of statistics through IRDA or a palmtop device with an RS232 connection (in EVA-DTS format).
In addition, Rondò can be banked alongside the Astro and the Oblò, using master or slave mode, which allows both machines to share a single payment system.
USER INTERFACE
Offering optimum product visibility for easy identification of the items and simple selection, via the 12 button numeric keypad and optional 5 direct selection button kit.
The direct selection button allows virtual selection (2 products with a single selection), and can be assigned to one or more spirals. This ensures that the machine empties evenly, the front of the machine always looks full and allows the promotion of high consumption products.
PAYMENT SYSTEMS
The payment systems and the electronic board are located inside a separate compartment, with independent access and slide-out opening for complete extraction, allowing work to take place in this area without affecting the temperature inside the product compartment.
Rondo is pre-set for the installation of systems with Executive and MDB protocol, as well as validators. The following can be installed on the same machine: